Just like the stars in the sky, traveling around the Corn Belt you cannot escape the hum of dryer fans on grain bins full of corn. The planting process challenged your patience, the maturity challenged your patience, and dry down challenged your patience.
With drying costs that are less expensive relative to other wet harvest years, many farmers have thrown in the towel and moved ahead harvesting corn with several more points of moisture than they would like.
That has necessitated firing up the heaters on the grain for the first time in two years. But drying corn with an attitude in October will also require patience.
Grain drying in October requires a special constitution. Many of the typical rules of thumb have long expired and success may require some creativity along with care and persistence. That is the advice of Ken Hellevang, quality specialist at North Dakota State University.
Aggravating the issue is the variable moisture throughout the field and in the grain as it enters the bin. Hellevang says, “Drought conditions usually lead to large variations in moisture content at harvest time, with ranges of from 15 to 25 percent in the same field. In fact, kernel moisture content, size and test weight likely will vary on an individual cob as well.
With varying moisture contents in the field, adjusting the combine for conditions will be more difficult, which may contribute to more fines in the corn.”
Fines will spoil faster since they can absorb more moisture, and they are created not only with aggressive harvesting but also when they are put into a bin. Since they will impede airflow, the air will travel around a core of fines and they may never dry properly.
Another issue is with the moisture variability in the corn, and it will enter and leave a dryer with variable moisture. Helevang says a dryer may take out 6 points of moisture, but if the corn is going in from 15 percent to 25 percent moisture, it will come out in a range of 11 percent to 19 percent.
He says the use of a fan will help more moisture from wetter to drier kernels, but without airflow the moisture migration will not occur. To help balance the moisture content, he recommends running the aeration fans longer than is required to cool the grain. The moisture may not equalize fully, but it will become more uniform.
If the corn is stressed and has a low test weight, the shelf life is shorter than normal; subsequently more diligence is needed in the drying and storage process. He suggests drying low test weight and stressed corn a percentage lower in moisture content than normal because of greater variations of moisture content in the grain mass and increased kernel damage and broken cobs, which could magnify storage mold problems.